![]() The CC-Link station address switches on the Anybus X-gateway, set A window willĭisplay all Anybus-based Ethernet interfaces, and their IP addresses, To configure Anybus based Ethernet interfaces.Ī PC with Ethernet connectivity, run the Anybus IPconfig. The HMS IP Configuration Protocol (HICP), which provides a simple way To install and configure an Anybus X-gateway:Īnd install the HMS Software utility Anybus IPconfig this utility uses ![]() These documents are available on the support page of the HMS website ( ). To the HMS Anybus-X documentation ( Anybus-XĮthernet Network Interface Addendum and X-gateway Interface Addendum - CC-Link Slave Interface), for more information. The procedure assumes that you are using the following components: The steps contained in this section explain how to install and configure the Ethernet portion of the Anybus X-gateway. ![]() Install and Configure an Anybus X-gateway A Mitsubishi Automation Controller that supports CC-Link.Running firmware version 3.41.00 or higher The examples in this topic were written assuming that you are using the following components: This topic explains how to install and configure the gateway, how to configure the Automation Controller programming software (Mitsubishi GX Developer), and how to set up In-Sight Explorer to communicate with a Mitsubishi Automation Controller on a CC-Link network. For more information, see Anybus X-gateway. OverviewĪn In-Sight vision system can communicate with devices on a CC-Link network using an Anybus X-gateway and TCP/IP Modbus protocol. For a complete list of models and supported firmware versions, see Firmware Versions. Note: CC-Link is only available on In-Sight vision systems using In-Sight firmware 4.x.x, and is not available on In-Sight vision systems running In-Sight firmware 5.1.0 and later.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |